How to replace the toilet flush

 

Replacing the toilet flush can be a crucial part of replacing a toilet, especially if the fittings and fixtures are very old or deteriorated. This can certainly be the case if the pipes are very old or compromised for some reason.

Most of them are made of PVC pipes, a very durable form of plastic that has been used for plumbing for many years. However, it is not indestructible and must be replaced for various reasons. Some people move the position of the toilet and use a staggered flush, or it can be damaged when removing the toilet. Here you will find the information you need to carry out the project.

Removing the toilet

Start by removing the toilet. Shut off the water supply and disconnect the hose from the tank. Flush the toilet to remove as much water as possible from the tank and stool. Use a plunger to remove any remaining water from the stool. Loosen and remove the nuts that secure the tank to the stool and lift the tank. Carefully lay the tank on a towel or blanket.

Next, loosen and remove the nuts of the anchor bolts holding the stool to the floor. Lift the stool off the bolts and lay it on a blanket. Remove the wax ring. This should expose the drain.

Remove existing drain

Start by trying to remove the existing drain by gently turning it clockwise. If the PVC glue is old, the drain can be rotated and removed. If it is not possible to remove the drain in this way, examine the drain to identify where the fittings are located. Try not to damage the joints, as this would mean replacing even more PVC. Otherwise, use the cutting blade of the dremel to cut around the damaged or worn section of PVC and remove the PVC section.

Install the new drain

Once the old flush has been removed, dry fit the new flush to ensure that all components do not need further modification to reinstall the toilet. If necessary, replace other PVC fittings until the desired angle and height of the drain is achieved. Once you are sure of the fit, apply purple PVC glue to all PVC inserts and make the connections.

Reinstallation of the toilet

Install the new wax ring. Reinstall the toilet in the reverse order in which it was removed. Do not over-tighten the stool or tank nuts, as this may cause the porcelain to crack, necessitating replacement of the stool, tank or both. Reconnect the water supply and be sure to use plumber's tape to ensure a tight seal. Once everything is reconnected, open the water and observe the absence of leakage through several flushes.

Call the Emergency Plumber in Oldham. We are 24 hours available. Call us now, 01613941085.