Emergency Services

  An even more important aspect than the immediate repair of leaks is their prevention. Of course, problems may occur from time to time, but it is best to keep the pipes maintained so that these problems remain minor and easily solved. Ensure that fittings and adapters are watertight An adapter is a curved piece of pipe used to connect other, usually straight pipes. It is essential to make sure that the fittings are tight to ensure that the pipes work properly without leaks. Ensure that all joints are properly sealed In addition to tightening the fittings, all joints must be well sealed. This is generally done with a sealant or plumber's tape, although it is advisable to consult a plumber before deciding which one to use. Pay attention to water pressure Most houses are equipped with a pressure gauge, which makes it easy to identify the water pressure. Generally, the water pressure in a residential house should be between 40 and 50 psi. If it is far above or below this range, it is...

 The hot water tank or water heater must be emptied once or twice a year because it can accumulate mineral deposits and sand. This causes the hot water tank to lose its efficiency and you have access to less hot water. Emptying the water tank is easy, here are the simple steps to do it. Switching off the water heater For gas hot water tanks, turn off the main gas switch, for electric hot water tanks, turn off the switch. Shut off the water supply to the tank. Allow the tank to cool for about two hours. Connect the garden hose Connect the garden hose to the drain valve at the base of the water tank and place the opposite end of the hose outside to drain the water. Allow the water tank to drain completely Open the hot water tap and the drain valve to ensure that the tank drains completely. After draining the tank, carefully reopen the valve that supplies cold water; wait at least five minutes and close the tank drain valve. Remove the garden hose. Close the tap with the hot water ta...

  The shut-off valves under your sink are your last line of defense when the faucet leaks, and they must always be in working order. Because they are rarely used under normal circumstances, the plastic and rubber parts inside such a valve can become brittle, and eventually it can leak. Before replacing a leaking valve , you can try a simple repair procedure. If it doesn't work, you'll have to replace the valve, but if it does work, you'll have saved a little time and money. Spray the handle with spray lubricant if it won't turn. Wait about five minutes and then try turning it again. Repeat the process if necessary. Stop a valve leak by tightening the packing nut. Wrap a rag around the nut located just below the valve handle, grasp it with adjustable pliers, and turn it clockwise one-eighth of a turn. This may compress the rubber and plastic inside enough to stop the leak. If not, disassemble the valve. Turn off the water in the sink. If you are repairing a hot water val...

  As with most clogged drains , the first method to try with a clogged tub is a toilet plunger. However, if plunging the drain doesn't yield results, the next step is drain relocation. Don't panic if you find that the drain hole doesn't have room for the snake - you can run the cable through the overflow plate instead. Often the drain blockage is at the plug of the drain, so you may not need the snake at all. If the clog is further down the drain, you may be able to solve the problem without the help of a plumber. Unscrew the metal plate under the tub faucet, called the overflow plate, making sure the screws don't fall into the drain. Remove the overflow plate. It is connected to the plug mechanism for the tub; pull it out through the hole behind the overflow plate as well. Put on rubber work gloves. Use a paper towel to remove any hair caught on the underside of the plug mechanism. If there is a large amount of hair stuck to the mechanism, this may be the cause of...